User Guide

– 9 –
6.5 Placing the Door/Window Contact
6.4 Mounting of the Door/Window Contact
Use the adhesive strip to mount the devie on the wall or the
window frame.
Sensor
Select a suitable place for the Door/Window Contact on the side of the windor or the door. The ideal distance
to the sensor is 3 mm. The sensor must be aligned with the window or the door.
For dark surfaces (e.g. brown window/door) you should place the reflecting sticker at the surface opposite
the Door/Window Contact.
6.6 Factory Reset
Note: After commissioning, the door/window contact requires 2-3 opening cycles to correctly detect the
movement stroke.
Press and hold the button in the housing of your Door/Window Contact for at least 10 seconds.
After successful reset, the red LED flashes twice and the green LED flashes three times.
Note:
After the reset, the Door/Window Contact switches to commissioning mode without reinserting the batteries.
Your primary Z-Wave controller will be informed about the performed reset.
Use the factory reset only if your primary Z-Wave controller is no longer available or is inoperative for other
reasons.