Installation Guide

9 HOMEDEPOT.COM
Please contact 1-800-305-1726 for further assistance.
Install Shelves
5
□ Make sure your shelves (G) t your closet layout design.
□ Hold the shelf’s (G) front rod, let it t into the bracket’s (H) front notches as
the diagram shows, then push down the shelf’s rear part allowing the
shelf’s rear horizontal rod to lock into the back clip of bracket.
NOTE: The bracket is supposed to be shared by two shelves in system as
shown on the right. Each end of shelf will take up half of bracket.
G
H
2
1
Two shelves
share one
bracket
NOTE: Closet rod brackets need to be installed BEFORE any decorative shelf
covers are installed on shelf.
Install Closet Rod Brackets and Closet Rod
6
□ Count 6 rods or more from one side of the wire shelf and install closet
rod brackets as shown. Maximum spacing between closet rod brackets
is 18 in. for this system (see Fig. 20).
□ Put the closet rod support bracket (M) at an angle as shown and place
the back part onto the horizontal rod (B) (see Fig. 21).
□ Pull down the closet rod support bracket (M) and snap onto the shelf's
front rod (C) (see Fig. 21 and Fig. 22).
Installation (continued)
Fig. 20
M M
Fig. 21 Fig. 22
M
L
6 rods or more
Max 18 in.
12
3
Rod C
Rod B