Installation Instructions

2017 3
Maintenance
Cleaning Schedule
To maintain proper efficiency of luminaire, a regular cleaning schedule needs to be established in regards to the placement, location and
conditions of product installation. Frequency of cleaning shall be to the discretion of the end user, but should be no less than every 90 days.
If conditions mandate, a more frequent cleaning schedule must be implemented. Improper cleaning may result in component malfunctions,
product failure and voidance of warranty.
Fixture Cleaning
• If applicable – use air to blow dust and debris from lens, hood, heatsinks and drivers before wiping with a cleaning solution.
• Use only mild, nonabrasive cleaners. Spray cleaner onto soft cloth and wipe surface of lens before wiping down other surfaces of
lighting fixture.
• If needed – use a very soft brush or duster to remove excess particles from between heatsinks, drivers or other difficult to reach areas.
• Note any damage (cracking, splitting, peeling, breaks). Contact local sales representative, distributor or EverLast Lighting Inc. if damage
replacement is necessary.
Hardware
• Fixture hardware shall be inspected before each cleaning.
• Check to make sure all hardware connections are secure. Make sure to tighten any loose screws, bolts, nuts, liquid tight connectors,
strain reliefs or electrical connections.
• Note any instances of damaged hardware. If any hardware is found to be consistently loose, damaged or questionable in any manner;
contact local sales representative, distributor or EverLast Lighting Inc.
Electrical Connections
• Check electrical connections each time maintenance is performed.
• Check to make sure all components (drivers, sensors, transformers, etc.) are properly connected and secured.
• Proper wiring connections and ground are imperative for fixture performance and customer safety.
Safety Cables (if applicable)
• Safety cables shall be regularly inspected during cleaning cycles.
• Check to make sure cables and connectors show no signs of damage. If damage is found contact local sales representative, distributor
or EverLast Lighting Inc. for replacements cables right away.
*Review EverLast Lighting Inc. warranty for a list of components covered under warranty.*
NOTE: For employee safety, all power connections shall be turned off or removed before performing any maintenance on lighting
fixtures. Persons performing maintenance shall be familiar with construction and operation of product, plus the hazards involved.