Instructions / Assembly

12
Evo, Inc., 20560 SW 115th Ave., Tualatin, OR 97062 USA
Phone [phone] | Fax [phone] | www.evoamerica.com | [e-mail]
Propane (LP) models have two leg supports (left-side
and front) that are installed using philips screws and
nyloc hex nuts. The third leg support (right-side)
is a removable with keyway cutouts that install over
pre-installed fasteners (see Removable Leg Support
below).
Natural Gas models have three leg supports (left-
side, right-side, and front) that are installed using
philips screws and nyloc hex nuts.
1. Position leg support to inside of leg with removable
installation label on leg support facing outward. Be sure
angle at each end of leg support matches inside
angle of leg.
2. Visually align screw holes and place phillips screw (30)
into fi rst mounting hole with nyloc hex nut securing leg
support from behind.
4. Tighten phillips screw to nyloc hex nut and ensure leg
support is engaged and leg support is secured against
inside of leg.
5. Repeat for all mounting holes of each leg support.
Leg Supports To Leg Frame
Assembling The Grill
Phillips Screw (30)
Nyloc Hex Nuts go to
backside
Propane (LP) Models Only
1. On LP models, two leg supports are installed to the leg
frame using 8 phillips screws and nyloc hex nuts. The
third leg support, located on the right-side of the grill, is
provided with keyway cutouts which allow easy removal
for exchanging the LP tank.
2. The fasteners necessary to engage the removable leg
support are pre-installed at the factory and require no
adjustment. These fasteners are tensioned with a spring
that secures the leg support to the right-front and rear
leg.
3. Position removable leg support on inside of leg with the
polished factory fi nish facing outward. Be sure angle at
each end of leg support matches inside angle of leg.
5. Visually align keyway holes and leg support over fasten-
ers.
6. Pull inward at each end of the leg support, and then push
downward to engage the keyway fasteners.
7. To remove the leg support, reverse the installation pro-
cess.
Removable Leg Support
Some parts may contain sharp edges.
Wear protective gloves as necessary.