Instructions / Assembly

15
Evo, Inc., 20560 SW 115th Ave., Tualatin, OR 97062 USA
Phone [phone] | Fax [phone] | www.evoamerica.com | [e-mail]
Assembling Your Grill
Hood Handle & Hood Support
1. Install handle to outside of hood by locating phillips
screws (70) through the handle and into the hood.
2. From inside hood, simultaneously install the hood support
with phillips screw.
3. Secure each philips screw (70) with two each lock
washer (71) and hex nut (72).
Tank Shield
Propane (LP) Models Only
Use Standard 20lb LP Tank
1. Lift tank shield over LP tank and position with shield cut-
out facing the tank valve. When LP tank and tank shield
are loaded into grill, the valve should be facing toward the
rear leg and inline with the tank shield cutout.
Some parts may contain sharp edges.
Wear protective gloves as necessary.
Tank valve facing
rearward and toward
tank shield cutout.
1. Install Rear Handle to rear of burner unit using two each
of phillips screw (60), and nyloc hex nut (61).
Rear Handle To Burner Unit