installation and_manual

INSTALLATION INSTRUCTIONS
A f f i n i t y 3 0 G
Evo, Inc., 20560 SW 115th Ave., Tualatin, OR 97062 USA
Phone [phone] | Fax [phone] | www.evoamerica.com | [e-mail]
18
STEP 7: Locate Parts Box shipped with your Affi nity 30G and the parts bag containing the
Rear Retaining Bullet Fastener, two each 1/4” x 20 hex bolt and locking nut, and two each
J-Hook. Follow the illustration show on this page, and using a 7/16” wrench tighten the Rear
Retaining Bullet to a cook surface tab as shown (Ensure the Rear Retaining Bullet is placed
on the right hand side of the tab). Next, loop the J-Hook through the inside slot of each
remaining tab.
ASSEMBLING COOK SURFACE RETAINING FASTENERS
IT IS RECOMMENDED THE COOKING SURFACE BE PLACED ON A PROTECTED
WORK SURFACE WITH THE FLANGE FACING UPWARD.
Place Rear Retaining
Bullet Fastener on right
hand side of tab.
Using a 7/16” wrench,
tighten the Rear
Retaining Bullet to the
cooking surface tab with
two each 1/4” x 20 hex
bolt and locking nut.
Ensure the bolts are
tightened securely.
Loop the J-Hook
through the inside slot
of two tabs as shown.