installation and_manual

INSTALLATION INSTRUCTIONS
A f f i n i t y 3 0 G
Evo, Inc., 20560 SW 115th Ave., Tualatin, OR 97062 USA
Phone [phone] | Fax [phone] | www.evoamerica.com | [e-mail]
24
STORAGE & REMOVAL OF LP GAS CYLINDER:
Never store LP gas cylinder indoors. When cooktop is stored indoors, shut cylinder
valve off and disconnect cylinder from grill and remove to an outdoor location. Cylinder
must be stored outdoors in well-ventilated area, away from and out of the reach of
children. Cylinder should not be allowed to remain in a high heat area such as a closed
car, trunk, or in direct sunlight.
Loosen coupling nut located on regulator and cylinder valve by turning counterclockwise using
hands only - do not use tools. Next loosen thumb screws securing cylinder to lower rack and
remove tank. Install safety cap over cylinder valve coupling.
Do not store spare LP gas cylinder under or near this appliance. Never fi ll cylinder
beyond 80% full. Cylinder must be constructed and marked in accordance with the
specifi cations for propane cylinders of the U.S. Department of Transportation (DOT), or
CAN/CSA B339. If the above information is not followed exactly, a fi re causing death or
serious injury may occur.
WARNING
STORAGE, REMOVAL and TRANSPORTATION OF LP CYLINDER
TRANSPORTATION OF LP CYLINDER:
Never remove or alter cylinder labeling. Labels contain critical information on the safe handling
of gas products. The DOT requires that proper labeling must be in place before the products
can be off ered for transportation.
Transporting cylinders in cars, vans, or in any enclosed vehicle is extremely dangerous, and
should be avoided. Never transport fl ammable gases in the trunk or passenger compartment of
a vehicle.
Always install the protective cap on the cylinders when they are being transported, or any
time they are not in use. If the cylinders were not designed to accept a protective cap over
the valve, special care must be taken to prevent the valve from damage or opening during
transportation.
Secure your cylinders. The Department of Transportation (DOT) regulations require that all
compressed gas cylinders be secured from movement during transportation. Cylinders that can
move can open accidentally, or roll off the vehicle into the path of oncoming traffi c.
Handling, storage and transportation of all gas cylinders must be in accordance with ANSI/
NFPA 58, Storage and Handling of Liquid Petroleum Gases, or CSA B149.1, Natural Gas and
Propane Installation Code.