installation and_manual

INSTALLATION INSTRUCTIONS
A f f i n i t y 3 0 G
Evo, Inc., 20560 SW 115th Ave., Tualatin, OR 97062 USA
Phone [phone] | Fax [phone] | www.evoamerica.com | [e-mail]
26
Gas Coupling Connected
Gas Coupling Disconnected
CHECKING GAS LEAKS (NATURAL GAS)
Do not ignite burners or use an open fl ame to check for gas leaks. Be sure there are no sparks
or open fl ames in the area while you check for gas leaks. Flames and sparks will result in a fi re
or explosion which can cause serious bodily injury or death and damage to property.
DANGER
Note: All factory-made connections have been thoroughly checked for gas leaks. The
burners and ignition system has been fl ame tested. As a safety precaution, we recommend
you recheck all fi ttings for leaks before using your Evo cooktop. Shipping and handling
may loosen or damage a gas fi tting.
To perform a leak check you will need a solution of soap and water and a brush or rag to
wet all gas connections.
1. Turn all control knobs to the OFF position.
2. Slide back the collar of the quick disconnect. Push the
male fi tting of the hose into the quick disconnect and
maintain pressure while releasing the collar.
3. If fi tting does not engage and lock, repeat procedure.
Gas will not fl ow unless the quick disconnect is properly
engaged.
4. Turn on gas supply and check for leaks by wetting the connections with the soap and water
solution and watching for bubbles. If bubbles appear, or if a bubble grows, there is a leak.
Note: Since some leak test solutions, including soap and water, may be slightly corrosive,
all connections should be rinsed with water after checking for leaks.
CHECK ALL GAS CONNECTIONS:
1. Hose to Manifold Connection.
Warning: If there is a leak where the hose connects to the manifold then retighten the fi tting with a wrench
and recheck for leaks with soap and water. If leak continues after retightening the fi tting, tun off gas. DO NOT
OPERATE COOKTOP. Contact your local dealer or Evo Customer Service using the contact information provided
with your manual.
2. Valves to Manifold Connections.
3. Hose to Quick Disconnect Connection.
WARNING
Perform leak checks even if your cooktop
was dealer or store assembled.
You should check for gas leaks every time
you disconnect and reconnect a gas fi tting.
WARNING
PLEASE POST THESE INSTRUCTIONS IN A PROMINENT LOCATION