installation and_manual

OPERATOR INSTRUCTIONS
A f f i n i t y 3 0 G
Evo, Inc., 20560 SW 115th Ave., Tualatin, OR 97062 USA
Phone [phone] | Fax [phone] | www.evoamerica.com | [e-mail]
30
LIGHTING INSTRUCTIONS
Electronic Ignitor Lighting Procedure:
1. Read instructions carefully before lighting.
2. Cooking surface must be in place and secure before
lighting.
3. Hold down the igniter button, then turn the Control
Knob to ‘Lite’. View the fl ame through the viewing
holes in the Grill body to confi rm it is lit. If the burner is
lit, turn the knob to ‘the desired setting to commence
cooking.
4. If ignition does not occur in 5 seconds release igniter,
turn the burner Control Knob off , wait 5 minutes, and
repeat lighting instructions.
If after the repeated attempt the burner does not ignite,
follow the manual lighting procedure below.
Manual Lighting Procedure:
1. To light the burner manually, feed a lit match through
one of the fl ame viewing holes in the burner skirt
above the control panel until it is close to the burner.
2. Turn the Control Knob to the ‘Lite’ position. View the
fl ame through the opposite viewing hole in the grill
body to confi rm it is lit. If the burner is lit, turn the knob
to the desired setting to commence cooking.
3. Once the burner has been lit, remove the match and
extinguish the match fl ame.
Control Knob
Match
BEFORE EACH USE: Inspect gas hose under unit. If it is evident there is excessive
abrasion or wear, or the hose is cut, please contact Evo for a replacement hose.
Igniter Button