Warranty

10
www.evolutionpowertools.com
CUTTING OPERATIONS
Refer to the Instruction Manual provided by
the manufacturer/supplier of the machine
tted.
WARNING: Remove any machine tted to
the stand before the stand is prepared for
storage.
Note: As during preparation, placing the
stand on end or upside down on a clean
work bench (or similar rigid work surface)
may help with the following procedure.
• Return (if necessary) the legs to their
minimum extension setting.
• Operate the relevant locking/
unlocking lever to release the leg
from its service position.
• Rotate and fold each leg into its
storage
position, ensuring that they lock in
place.
Use the carrying handle (and/or extra
competent help) to transport the stand to a
dry, secure storage location.
MAINTENANCE
Keep the stand clean and free from the
debris that will be generated by any
cutting process. Such debris will inevitably
nd its way into the mechanisms of this
stand. Remove any such debris using a
soft, long haired brush. Observe such
Health and Safety precautions that may be
appropriate.
Do not use solvents or similar products that
may damage the plastic parts.
Use a light machine oil to lubricate the
pivot points and hinges of this machine
after any accumulated debris has been
removed.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your Local Authority or retailer for recycling
advice.