Warranty

9
www.evolutionpowertools.com
EN
Fig. 17
Note: Height-adjustable secondary clamps are provided
on the adjustable clamps. (Fig. 17).
This feature enables these clamps to be congured
to accommodate the wide variety of chopsaw bases
presently available from various manufacturers.
Note: Evolution pressed steel bases and some other
brand bases have a lip at the bottom of the base. If your
saw has a lip that protrudes under the clamp then you do
not need to t the secondary top clamp. (Fig. 18)
If your saw base does NOT have a lip that protrudes under
the clamp, then the secondary clamp MUST be attached
to secure the base from the top. (Fig. 19)
If the secondary top clamps are being used, ensure that
they are attached to the left hand side of the base and
that they do not interfere with the cutting path of the
blade. Conduct a test to ensure the blade operates freely
before turning on the machine.
Attaching a Chop Saw to the Universal Mounting Table
• Place the chop saw onto the table with the right
hand (RH) edge of the machine’s base resting against
the two xed clamps.
• Adjust the adjustable clamps to rmly grip the base
of the machine.
• If necessary adjust the secondary clamps to provide
enhanced positive location and extra grip to the
upper surface of the chop saw base. (Fig.19) Tighten
these in place using the supplied hex key.
• Tighten the clamps to secure the machine onto the
table.
Note: When tting your chop saw to the stand please
ensure the moving clamps are to the left of the unit when
viewing from the front. (Fig.20)
Test the security of the machine by gently trying to rock
the machine backwards and forwards. There should be no
detectable movement of the machine on the table.
Fig. 18
Fig. 19
Fig. 20