Instruction manual

50
CAUTION: You must adjust your aircraft’s center of gravity and balance
your model properly before attempting flights.
ACHTUNG: Der Schwerpunkt muß vor dem Erstflug korrekt
ausbalanciert sein.
ATTENZIONE: prima di andare in volo è necessario regolare
accuratamente la posizione del Baricentro (CG).
CENTER OF GRAVITY
An important part of preparing the aircraft for flight is properly balancing the
model.
1. Attach the wing panels to the fuselage. Make su re to connect the leads from
the aileron to the appropriate leads from the receiver. Make sure the leads are not
exposed outside the fuselage before tightening the wing bolts. Your model should
be flight-ready before balancing.
2. The recommended Center of Gravity (CG) location for your model is 4.0–4.5
inches (103–114mm) behind the leading edge at the wing centerline as shown.
Mark the location of the CG on the top of the wing. Extend the line 3 inches
(76mm) on either side of the wing centerline. Mount the wing to the fuselage.
3. When balancing your model, make sure it is assembled and ready for flight.
Using an assistant, lift the model at the locations marked in the previous step.
This is the correct balance point for your model.
DER SCHWERPUNKT
Ein sehr wichtiger Teil in der Flugvorbereitung ist es das Flugzeug richtig
auszubalancieren.
1. Montieren Sie Tragflächen am Rumpf. Stellen Sie sicher, dass die
Querruderservoanschlüsse in die richtigen Buchsen am Empfänger gesteckt sind.
Achten Sie darauf, dass keine Kabel zwischen Rumpf und Fläche herausschauen.
Das Modell sollte vor dem Balancieren flugfertig ausgerüstet sein.
2. Der empfohlene Schwerpunkt für ihr Modell befindet sich 103 - 114mm hinter
der Tragflächenvorderkante an der Tragflächemitte gemessen. Markieren Sie den
Schwerpunkt auf der Tragfläche und ziehen die Linie 76mm zu beiden Seiten nach
aussen. Montieren Sie die Tragfläche am Rumpf. (siehe Abildungen)
3. Das Modell sollte vor dem Ausbalancieren flugfertig ausgerüstet sein. Heben Sie
das Modell mithilfe einer zweiten Person an den im vorherigen Schritt markierten
Stellen hoch. Dies ist der richtige Balancepunkt für Ihr Modell.

Un punto importante per preparare l’aereo al volo è quello di fare un centraggio
corretto.
1. Fissare l’ala alla fusoliera e collegare le prolunghe dei servi alettoni al relativo
canale sul ricevitore. Bisogna fare attenzione che queste prolunghe non sporgano
dalla fusoliera quando si fissa l’ala. Il modello dovrebbe essere pronto al volo
prima del bilanciamento.
2. La posizione del baricentro consigliata si trova tra 103 e 114mm dietro al bordo
di entrata dell’ala al centro, come si vede nella foto. Segnare la posizione del
baricentro (CG) sulla parte superiore dell’ala. Allungare poi questo segno di 76mm
su entrambi i lati rispetto alla linea centrale dell’ala. Montare l’ala sulla fusoliera.
3. Quando si bilancia il modello, verificare che sia correttamente assemblato
e pronto al volo. Con l’aiuto di un’altra persona, sollevare il modello dai punti
segnati nel passaggio precedente. Tale posizione indica il punto di equilibrio
corretto del modello.