User guide

12 13
Drive Mode The Smart iCopter comes with the ability to be driven on the ground. Use the Drive Mode to familiarize yourself on directional controls of the Smart iCopter before taking to the air.
Press “Lift O ” button to take o . In Easy-Fly mode, the height is preset between 2.6 - 3.9 feet (0.8 - 1.2 meter). Press Land button to land your Smart iCopter.
Ready, Set, Lift O ... Once you are comfortable with the directional controls, with a single touch of the Easy-Fly One Touch “Lift O and Auto Hover” feature, launch your Smart iCopter into the air.
Press and hold “Ignition” button until rotor blades start to turn. Use the directional control to Drive your Smart iCopter on the ground. Use Altitude slider to increase power during drive mode. Press and hold Engine Stop to stop.
Only drive the Smart iCopter on a  at solid surface. Wheels may get caught on carpeted  oor or cause the Smart iCopter to be o balanced.
Recommended to  y on  at solid surface to avoid erratic  ight. Soft or carpeted surface may interfere with height sensor signal.
During Lift O please note that your Smart iCopter will tilt in unexpected direction due to turbulence, ground e ects or outside interference, compensate by gently pulling the controls in the opposite direction.
Lift O Land
Ignition
Engine Stop
Easy-Fly; One-Touch Simplicity Flying Those who had experience  ying traditional RC helicopters know it is a challenge and the learning curve is usually a painful and frustrating process.
With our proprietary and Patent Pending Easy-Fly features, you can now enjoy instant  ying experience with our One Touch approach to  ying.
Altitude Slider In-Flight Adjustable slider In Easy-Fly mode, the height is preset between 2.6 - 3.9 feet (0.8 - 1.2 meter) for optimum sensor detection Please note that your Smart iCopter uses on board sound sensor to detect surface to height changes, i.e.  ying over table or other furniture, and it will auto correct its altitude accordingly.
Trim (Rudder) Should your helicopter begin to drift in a certain direction or spin erratically, you will need to adjust your trim to regain control. In order to trim your chopper, move the Trim Dial in the opposite direction that your helicopter is drifting/spinning.
XC9847IS01EXC.indd 12-13XC9847IS01EXC.indd 12-13 8/1/12 5:08 PM8/1/12 5:08 PM