Product Warranty

3. Front Handlebar Post and Foot Pedal Installation
Remove four Bolts (23) and four Curve Washers (25) from the Front Main Frame (5).
Slide the Front Handlebar Post Cover (74) up to the Front Handlebar Post (6).Insert the
Tension Cable (40) through into the bottom hole of Front Handlebar Post (6) and pull it
out from the square hole of Front Handlebar Post (6).
Connect the Sensor Wire (61) and Extension Hand Pulse Sensor Wires (65) from the
Front Main Frame (5) to the Extension Sensor Wire (64) and Extension Wires (63) from
the Front Handlebar Post (6). Insert the Front Handlebar Post (6) onto the tube of the
Front Main Frame (5) and secure with four Bolts (23) and four Curve Washers (25) that
were removed. Slide the Front Handlebar Post Cover (74) down to the Front Main
Frame (5). Remove the Bolt (36) and Big Curve Washer (38) from the Tension
Control Knob (14).
Put the cable end of resistance cable of Tension Control Knob (14) into the spring hook
of Tension Cable (40) as shown in drawing A. Pull the resistance cable of Tension
Control Knob(14) up and force it into the gap of metal bracket of Tension Cable (40)
and gently remove the Clip (80) after well-connected the resistance cable of Tension
Control Knob (14) and Tension Cable (40) as shown in drawing B. Attach the Tension
Control Knob (14) onto the Front Handlebar Post (6) with the Bolt (36) and Big Curve
Washer (38) that were removed.
6mm Allen Wrench
Tool:
ASSEMBLY
13
Multi Hex Tool with
Phillips Screwdriver