Product Warranty

5. Seat Sliding Tube, Back/Seat Support Bracket, and Handlebar Installation
Remove eight Bolts (23) and eight Washers (24) from the Back/Seat Support Bracket
(1) and Seat Sliding Tube (15). Remove bolts with the Allen Wrench provided.
Insert the Seat Sliding Tube (15) into the Bushings (54) of the Rear Main Frame (3).
Attach the Seat Sliding Tube (15) to the Back and Seat Support Bracket (1) with eight
Bolts (23) and eight washers (24) that were removed. Tighten bolts with the Allen
Wrench provided.
Attach the Handlebar (13) onto the Back and Seat Support Bracket (1) with two Bolts
(70), two Curve Washers (25), two Washers (24), and two Cap Nuts (32). Tighten bolts
with the Multi Hex Tool with Phillips Screwdriver provided. Connect the Middle Section
Hand Pulse Sensor Wires (55) from the Rear Main Frame (3) to the Hand Pulse
Sensor Wire (68) from the Handlebar (13).
ASSEMBLY
6mm Allen Wrench
Tool:
15
Multi Hex Tool with
Phillips Screwdriver
(70) Bolt
2 PCS
(25) Curve Washer
2 PCS
(24) Washer
2 PCS
(32) Cap Nut
2 PCS
Hardware: