Operation Manual

25
Anti boil-dry device
If you switch the appliance on without
havinglleditwithwater,orwhenthe
water level is below the “MIN” mark, the
antiboil-drydevicewillautomatically
switch it off. The appliance can be
switched on normally as soon as it is
lledwithasufcientamountofwater.
CLEANING
When cleaning the appliance, you
should pay attention to the following:
• Removetheplugfromthemains
socket, and allow the appliance
to cool down completely before
cleaning it.
• Neversubmergetheappliance
base, cord or plug in water, and no
water must be allowed to enter the
appliance base.
• Cleantheapplianceandbaseby
wiping with a damp cloth. A little
detergent can be added if the
appliance is heavily soiled.
• Donotusescouringpads,steel
wool or any form of strong solvents
or abrasive cleaning agents to
clean the appliance, as they can
damage the external surfaces of the
appliance.
• Removethelimescalelter(1)from
the appliance and carefully clean it
withasoftbrush.Removethelter
by pulling it upwards and out of
theholder.Replacethelterinthe
appliance after cleaning.
• IMPORTANT!Allowtheapplianceto
dry fully after cleaning before using
again. The appliance must not be
used if the base or the underside of
the appliance is wet.
• Ensuretheapplianceiscleanand
dry before storage.
DESCALING
The lime content of ordinary tap water
means lime scale may gradually be
deposited inside the appliance. This
lime scale may be loosened using acetic
acid (NOT ordinary vinegar) or descaler,
available in supermarkets, etc.
1. Mix100mlaceticacidwith300ml
cold water, or follow the instructions
on the descaler packaging.
2. Pour the solution into the appliance
andswitchonusingtheOn/Off
button.
3. Boiluntiltheapplianceswitchesoff
automatically.
4. Leave the solution in the appliance
forapprox.10minutesbefore
emptying.
5. To remove the last residues of
limescaleandaceticacid,llthe
appliance with fresh cold water
and boil. Do this three times. The
appliance is now ready for use.
FOR UNITED KINGDOM ONLY
Plug wiring:
ThisproductisttedwithaBS1363
13-ampplug.Ifyouhavetoreplacethe
fuse, only those that are ASTA or BSI
approvedtoBS1362andwitharated
currentof13ampsshouldbeused.If
thereisafusecovertted,thiscover
mustberettedafterchangingthefuse.
If the fuse cover is lost or damaged, the
plug must not be used. You must also
check if the socket outlets in your home
twiththeplugoftheappliance.Ifthe
socketoutletinyourhomedoesnott
with the plug, the plug must be removed
and disposed of safely as insertion of
the plug into the socket is likely to cause
electrichazard.Areplacementplug
should be wired according to following
description.