Operation Manual

18
19
KEY TO THE MAIN COMPONENTS OF THE
APPLIANCE
Mixing bowl1.
Paddle2.
Fixed bowl3.
Socket for motor section4.
Mixing indicator (MIXING)5.
Display6.
Timer button7.
Start/stop button8.
On/off switch (POWER)9.
Cooling indicator (COOLING)10.
Compressor11.
5-pin plug12.
Spindle13.
Motor section14.
Filling port (under the cover)15.
Filling port cover16.
See-through lid17.
Measuring cup and ice cream scoop included.
PRIOR TO FIRST USE
Remove all packaging and transport materials from •
the inside and outside of the appliance.
Check that the appliance has no visible damage and •
that no parts are missing.
Clean all parts that come into contact with food •
beforeusingtheapplianceforthersttime(orafter
prolonged storage). See “Cleaning”.
Please note: It is not necessary to place the mixing
bowl (1) in the freezer before use, as the appliance has
a built-in compressor (11), which cools the ice cream or
sorbet mixture.
USING THE APPLIANCE
Assembling the appliance
Placethemixingbowlinthexedbowl(3).1.
Mount the paddle (2) in the mixing bowl in a 2.
crosswise position. The end with the collar and the
square hole should point upwards.
Mount the see-through lid (17) on top of the 3.
mixing bowl. Make sure that the top of the paddle
issecurelyxedintheholeinthemiddleofthe
lid. Turn the lid slightly clockwise, so it locks into
position.
Placethecover(16)overthellingport(15)inthe4.
lid.
Mount the motor section (14) by inserting the 5.
spindle (13) into the hole in the lid. The 5-pin plug
(12) on the motor section will slide into place in the
socket (4) on the compressor.
Procedure for making ice cream or sorbet
Check that the appliance is correctly assembled.1.
Connect the appliance.2.
Press the on/off button (9) to switch on the 3.
appliance. The appliance is now in standby and
the display (6) shows “60:00”, which indicates the
standard setting of 60 minutes.
Set the desired preparation time by pressing the 4.
timer button (7) a number of times. The preparation
time can be set at 10, 20, 30, 40, 50 or 60 minutes.
Press the start/stop button (8) to commence 5.
preparation. The green mixing indicator (5) lights up
and the appliance starts mixing. The display counts
down from the set preparation time.
The appliance must be switched on before the o
ice cream or sorbet mixture is added, as the
mixture may otherwise freeze solid, making it
impossible for the paddle to turn!
Add the ice cream or sorbet mixture by pouring it 6.
throughthellingport.
Make sure there is always at least 2.5 cm o
between the mixture and the top of the bowl, as
the mixture expands when frozen.
After two minutes of mixing, the red cooling o
indicator (10) comes on, and the appliance starts
cooling.
Do not add ingredients such as chocolate o
pieces,nutsoralcoholthroughthellingport
until the ice cream is almost ready.
Leave the appliance to cool until the end of the set 7.
preparation time.
You can increase the preparation time during o
preparation by pressing the timer button a
number of times. Each time you press the
button, the preparation time increases by 5
minutes.
You can stop the appliance before the set o
time by holding down the start/stop button for
3 seconds or by pressing the on/off switch.
Caution! Do NOT stop the appliance during
preparation, as the ice cream mixture may freeze
solid and prevent the paddle from turning when
the appliance is switched on again.