User Manual

Table Of Contents

Filling The Rinse Aid Reservoir

Close the cap after all.

Remove the rinse reservoir cap by

lifting up the handle .

Pour the rinse aid into the dispenser,

being careful not to overﬁll.

Adjusting the rinse aid reservoir

To achieve a better drying performance with limited rinse aid, the dishwasher is

designed to adjust the consumption by user. Follow the below steps.

1. Power on the dishwasher by plugging in;

2. Within 60 seconds after step 1, press the Rapid button more than 5 seconds,

and then press the Delay Button to enter the set model, the rinse aid indication

blinks as 1Hz frequency.

3. Press the Rapid button to select the proper set according to your using habits ,

the sets will change in the following sequence: D1->D2->D3->D4->D5->D1,

Dispenser drops more rinse aid in D5 level than in another, the manufactory setting

is D3.

4. Without operation in 5 seconds or press the power button to exit the set model,

the set success.

Amount of rinse aid (mL)Selector position

1.2

2.4

3.6

4.8

6.0

