User Guide

11
Check to see that both tail panel latches make proper contact with the EnCore side rails.
If tail panel latch
doesnʼt contact side
rail properly…
…hand-loosen latch screws
and slide the latch toward
the side rail.
Retighten
screws by hand.
If the tail panel latch is
not tight to the EnCore
side rail, add spacer to
side rail lip.
Extang Corporation, 5400 S. State Road, Ann Arbor, MI 48108, 734 677-0444, Fax: [phone]
Visit us at: extang.com
Rotate lock cylinder (unlocked) 1/4 turn (90
degrees) clockwise two to three times to ensure
lock snaps back to original position.
12
Ensure Front Panel Latch is Functioning Properly
Verify front panel is
securely latched on
both sides of truck.
SECURE THE FOLDED ENCORE COVER TO FRONT OF CAB WITH BOTH CAB
BUCKLES. DOUBLE CHECK TO BE SURE BUCKLES ARE SECURELY FASTENED. ALSO
SECURE TETHERS LOCATED ON THE CENTER PANEL TO EACH SIDE RAIL. VEHICLE
MAY BE DRIVEN WITH THE COVER IN THIS SECURE, FOLDED POSITION.
Check For Tail Panel Latch Engagement
Do Not Drive the
vehicle with the
tonneau cover on
the truck until the
lock snaps back to
original position and
the front panel is
securely latched on
both sides of truck!
With tailgate open, unfold tail
panel and press down onto
truck bed.
Tonneau should now
be secure.
9
NOTE: To insure a
better seal, always
close panel before closing
tailgate.
Before this step,
be sure you
UNLOCK the
panel latch.
Unfold front panel and position
cab and middle panels over
truck bed making sure retaining
hooks engage pins in drain rail.
Press down on cab panel to lock
in place
10
Remove any snow or foreign matter
before folding cover.