User's Guide

h. Enable SNMP and enter passwords for the Read/Write community. Then, enter password for a
Trap Destination including your server IP address.
Note
You must also add the Trap Community and destination to get traps on your server.
This can be done from the server CLI: ADSPadmin > Config > SNMP Enable.
i. Click Apply.
10. Ensure that the device firmware is current. (Configuration > Infrastructure Management > Device
Firmware). If firmware is not current, update it.
11. Create a Radio Settings configuration for the device and apply it to the floor the device is placed.
You must include some data rates.
a. Go to Configuration > Infrastructure Management > Radio Settings.
b. Select the floor.
c. Select Override settings.
d. Select the proper settings.
e. Click Apply.
12. Configure RF-Domain and apply to by selecting the scope where the floor is placed on as follows:
a. Go to Configuration > Infrastructure Management > RF-Domain.
b. Select the floor.
c. Select Override settings.
d. Enter RF-Domain information.
e. Click Apply.
13. Create WLAN profile and apply it by associating the profile with the location that contains the
managed device.
a. Go to Configuration > Infrastructure Management > WLAN Profiles.
b. Click New Profile.
c. Enter information for the WLAN Profile in the General and Security tabs.
d. Click OK.
e. Ensure that the appliance is selected in the network tree and select Enable configuration.
f. Select the floor.
g. Select Override settings.
h. Select the WLAN Profile.
i. Click Apply.
The profile is now complete but ADSP cannot communicate with the Cisco device.
14. If you have not already done so during the Appliance Platform configuration, import the device into
your network using SNMP discovery using a single IP address. This can be done with Configuration >
Appliance Platform > Import/Discover Devices.
Note
Select SNMP discovery with a target folder of a floor created in the Appliance Platform
configuration. You can use the Device Import Rules or manually select the floor.
15. Set automatic status polling and automatic data collection for 3 minutes, and turn on automatic
configuration correction (Configuration > Appliance Platform > Polling).
Legacy Content
Account Management
Extreme AirDefense User Guide for version 10.5. 1267