User's Guide

Click the Data Table button to switch back to the table view.
If more than 50,000 frames have been captured during the live monitoring session, only the most
recent 50,000 frames are displayed.
Frames data is displayed as follows:
• Frames table (located on top)
• Hex values for a selected frame (located on bottom left)
• Decodes for a selected frame (located on bottom right).
Table View
The frame table can be customized to display the following information:
Column Description
Time Displays the time the frame was seen.
Source Lists the device where the frame originated.
Destination Lists the device where the frame was sent.
BSSID Displays the Basic Service Set Identifier.
Transmitter Lists the device that transmitted the frame.
Receiver Lists the device that actually received the frame.
Address 1 Lists the first address in the frame.
Address 2 Lists the second address in the frame.
Address 3 Lists the third address in the frame.
Address 4 Lists the fourth address in the frame.
Observed Channel Lists the WLAN channel that the device is operating on.
Channel Extension Lists the WLAN channel extension that the device is operating on.
Rate Displays the data rate (in Mbps) being used by the device that sent
the packet.
Signal (dBm) Lists the device's signal strength connectivity on the WLAN.
Size Displays the size of the frame.
802.11 Type Displays the 802.11 protocol type used in the frame.
Protocol Displays the protocol type used in the frame.
Sensor Displays the MAC address of the sensor that observed the device
that sent the packet.
Column display and arrangement can be customized as follows:
• Hide or unhide a category by right-clicking in the column heading area, and uncheck or checking the
checkbox for a category (see below).
Legacy Content
Drop-down Menu Access
Extreme AirDefense User Guide for version 10.5. 1313