User's Guide

You must click OK to continue. You can turn the warning o by selecting the checkbox next to Don't
show this warning again.
There are three conditions that may prevent a scan from starting. They are:
• The Sensor is already running a dedicated RF scan for any user
• Another user is running Live View on the Sensor
• Ten scans are already running (maximum supported).
You can stop a scan by clicking the Stop Scan button or selecting Scan > Stop Scan. A scan can be
restarted by clicking the Start Scan button or selecting Scan > Start Scan.
A counter is displayed next to the Stop Scan button to show how long the scan has been running.
The default scanning time is 10 minutes. Scanning time can be adjusted by selecting Configuration >
Appliance Management > Appliance Settings. If a timeout occurs, the following Scan Timeout popup
is displayed:
Click OK to close the popup.
Spectrum Settings
Spectrum View lets you adjust the pulse definition via the Spectrum Settings window. To access the
Spectrum Settings, select File > Settings.
As you can see, there are two fields for pulse definition: Threshold and Width. You can adjust the pulse
threshold by typing in a new value in dBm. You can adjust the pulse width by typing in a new value in
microseconds. Click OK to set the new values and close the window.
Scanning Modes
Drop-down Menu Access
Legacy Content
1328 Extreme AirDefense User Guide for version 10.5.