User's Guide

Infrastructure Management
Infrastructure Management is used to configure devices so that they can communicate on your network.
Device Firmware
Device Firmware configuration allows you to upload new AP or sensor firmware from a workstation to a
network server. Once the firmware is uploaded, you can upgrade your APs and/or sensors using
AirDefense.
Uploaded firmware images are listed by device type, version number, and image file name.
Use the Upload Firmware Image button to upload firmware.
Channel Settings
Use Channel Settings to select power and channel settings for the B/N/G radio and the A/N radio. The
settings are applied to APs and wireless switches.
By default, Channel Settings are enabled, and are set for maximum power and automatic channel
selection. The configuration fields for each radio are:
Setting Description
Power (dBM) Enter the maximum power value (in dBm) that APs and wireless
switches must have. Default setting is 20 dBm.
Channel Selection Select one of three options:
• Automatic—ADSP automatically sets which channel is used.
• Manual—Select a channel to use from the drop-down menu
and then select the extension range (none, upper, or lower).
• Random—ADSP randomly sets the channel
Default setting is Automatic.
Radio Settings
Radio Settings allow you to specify the radio settings used in your network. Using AirDefense, you
specify the supported rates and other settings for each radio. If a radio in your network is detected
operating outside the set specifications, AirDefense issues an alarm.
The settings apply to APs and wireless switches. You may also define a radio as a sensor. There are three
possible radio configurations:
• B/G/N Radio
• A/N Radio
• 3rd Radio.
By default, Radio Settings are enabled, and all data rates are selected for both 2.4 and 5Ghz radio
settings. Use the individual radio tabs to configure each radio.
Legacy Content
Infrastructure Management
Extreme AirDefense User Guide for version 10.5. 1391