User's Guide

Set the following parameters
Field Description
Enable Air Termination Air Termination lets you terminate the connection between your
wireless LAN and any access point or station associated with it. By
default, Air Termination is disabled. It can only be enabled in the
Appliance Manager.
Enable Background SA Scan Spectrum Analysis (SA) can be run as a background process. Use
this switch to run SA as a background process. By default,
background scans are disabled.
Enable WEP Cloak WEP Cloaking is an add-on tool that injects noise into a WEP-
protected environment by transmitting frames that appear to be
sourced from valid devices but are encrypted with an invalid WEP
key. By default, WEP Cloaking is disabled.
Enable Adaptive Scan Initially scans the selected channels and then adjusts the scan to
concentrate on the channels with the most trac. By default,
Adaptive Scan is disabled.
Enable Location Tracking RSSI
Scan
Devices can report RSSI scan data to AirDefense. This option allows
you to use that data in location tracking these devices. Once this
option is selected, you can adjust the location tracking refresh rate
from 1 to 60 seconds in the Refresh Rate control. The optimal rate is
1 second. (You must have a Proximity and Analytics license before
this option is visible.)
Spectrum Settings
The Spectrum Settings control in the Sensor Manager screen controls the Advanced Spectrum Analysis
(ASA) configuration parameters.
Set the following parameters:
The settings in this control are for the Advanced Spectrum Analysis In-Line based scan. They are not for
the Dedicated scan. Four settings are available for configuration, two (2) each for the 2.4 GHz and 5.0
GHz bands. The values in these fields are the default settings for these bands. These settings will work
for normal use and they should not have to be changed.
Configuration
Operation Tab
Extreme AirDefense User Guide for version 10.5. 247