User's Guide

You have an option to enable polling for supported devices. When enabled, WMS automatically polls for
device network status at an interval defined by a user supplied frequency value (default frequency is 1
hour).
You may configure polling at the appliance network level all the way down to the floor network level,
but you should always configure polling at the appliance level. Any network level below the appliance
level will inherit the configuration. If you need to have a dierent configuration below the appliance
level, use the Override settings option.
Note
The Override settings option is available when you select (highlight) a network level below
the appliance level. Use the Expand button to reveal the other levels.
Select the Enable automatic status polling checkbox to enable polling for supported devices. When
enabled, WMS automatically polls for device network status at an interval defined by the supplied
Frequency value.
Each device model has an associated data collection profile which identifies the list of attributes
collected periodically from the device. Select the Enable automatic data collection checkbox to collect
these SNMP attributes at a Frequency defined by you. You can also select the Automatically correct
configuration compliance violations checkbox to enable ADSP to correct configuration compliance
violations by uploading the last approved configuration to the target device.
The following features can be enabled by selecting the appropriate checkbox:
• ACL
• Port suppression
Polling
Configuration Tab
528 Extreme AirDefense User Guide for version 10.5.