User's Guide

◦ Three (minimum) AirDefense compatible sensors per map loaded.
Importing Maps
To use the built-in Location Tracking feature, you will need to import a map first and place the sensors
at their specific locations.
Note
Each map can be loaded by floor. You may have to re-arrange the sensors to accommodate a
map for each floor. You will also need a minimum of three sensors per map.
Note
A map can only be linked to sensors on the same floor. In a multi floor building, sensors
should be grouped by floors and each floor associated with its own map. At least 3 sensors
per floor plan are required for location triangulation.
Example:
If a location has 2 floors, there must be at least three sensors on each floor (total of six) for Location
Tracking to work.
Floor Manipulation Tools
The floor manipulation tools (located near the top-ride side of the windows allow you to adjust the size
of the floor plan image with a single click and/or move the floor plan image by dragging it to a new
position.
The following tools are available:
Tool Description
Click this tool to zoom in (enlarge the size) a floor plan image. Each
click will zoom closer.
Click this tool to zoom out (reduce the size) a floor plan image.
Each click will zoom out further.
Click this tool to fill the floor plan area with an image. Depending on
the size of the image, the image will expand to fit or reduce to fit
the floor plan area.
Click this tool to move/re-position the floor plan image. After
clicking the tool, use the hand (click and hold) to move/re-position
the image.
Setting Images
Select an empty floor and then click the Design Floorplan link to import a map. This will open a sub-
window and you can upload the appropriate map, which can be in .gif, .jpg, or .bmp files. Select the
Device Functions Requiring More Explanation
Configuration Tab
782 Extreme AirDefense User Guide for version 10.5.