- Extron Electronics Universal Interface Specification Sheet

1-2 RGB 302 • Specifications
Specifications — RGB 302 Universal Interface
Video
Gain ............................................... 0.35V to 1.45V p-p
Bandwidth .................................... 220 MHz (-3dB)
Video input
Number/signal type ................... 1 analog/ECL RGBHV, RGBS, RGsB, RsGsBs
Connectors .................................... 1 9-pin male for MBC/LBC cable or buffer
Minimum/maximum levels ...... Analog ....... 0.3V to 1.45V p-p with no offset at unity gain
Impedance .................................... 75 ohms or HiZ, switchable (set to 75 ohms if no local monitor is connected)
Horizontal frequency .................. Autoscan 15 kHz to 125 kHz
Vertical frequency ....................... Autoscan 30 Hz to 120 Hz
LCD horizontal frequency.......... 10 kHz to 150 kHz
LCD vertical frequency ............... 30 Hz to 200 Hz
Return loss .................................... -30dB @ 5 MHz
Maximum DC offset .................... 4.0V
Video output
Number/signal type ................... 1 analog RGBHV, RGBS, RGsB
Connectors .................................... 5 BNC female
Minimum/maximum levels ...... 0.35V to 1.45V p-p with 0.7V p-p input
Impedance .................................... 75 ohms
Return loss .................................... -30dB @ 5 MHz
Sync
Input type ..................................... RGBHV TTL (±), RGBS TTL (±), RGsB (-) 0.3Vm RsGsBs (-) 1.3V
Output type .................................. Autodetect RGBHV (±), RGBS (±), RGsB (-)
Input level ..................................... 2V to 5.5V p-p with ±0.2VDC offset max.
Output level.................................. 4V to 5V p-p
Input impedance .......................... 10 kohms
Output impedance....................... 75 ohms
Input sensitivity ........................... 0.3V to 5V p-p
Max. propagation delay.............. 48 nS
Max. rise/fall time ....................... 3.5 nS
Polarity .......................................... RGBHV ...................... when input is RGBHV, polarity follows input; otherwise
negative
RGBS, RGsB .............. negative
Audio
Gain ............................................... Unbalanced 0dB, balanced +6dB
Frequency response..................... 20 Hz to 20 kHz, ±0.05dB
THD + Noise ................................ 0.03% @ 1 kHz, 0.3% @ 20 kHz at rated maximum output drive
S/N ................................................ >90dB at rated maximum output (14dBu), balanced
Stereo channel separation ........... >95dB @ 1 kHz to 20 kHz
Audio input
Number/signal type ................... 1 PC level stereo, unbalanced
Connectors .................................... 1 3.5 mm stereo jack, female (2 channel); tip (L), ring (R), sleeve (ground)
Impedance .................................... >10 kohms unbalanced, DC coupled
Minimum level............................. 100mV
Maximum level ............................ +8.5dBu, (balanced or unbalanced) at stated %THD+N