User`s manual

IRCM-DV+ • Installation and Operation
IRCM-DV+ • Installation and Operation
Installation and Operation, cont’d
An IRCM-DV+ connected to an MLC 206 and another
control module
6. Connect one IR Emitter to the MLC’s Display/Source
Control IR connector for each IRCM control module that is
part of the system (up to 4 IR Emitters, maximum), or
connect an IR Broadcaster instead. Install two IR Emitters
for each IRCM-DV+. See the wiring illustrations below.
For the IR Emitter only
IR
Emitter
White striped wire only
A
BCDE
IR
Modulated IR
Ground
MLC
IR control
port
110 feet (33.5 m) maximum
Connect
up to 4 IR
Emitters
(max.).
D
A
+12VDC output
For the IR Broadcaster with emitter port
MLC
IR control
port
A
BCDE
IR
Modulated IR
Ground
To IR Broadcaster
with emitter port
(#60-272-02)
E
D
A
2-72-6
IR Emitter
(Connect 2 per IRCM-DV+ and
1 per each additional IRCM.)
Additional Control Module
Rear View
MLC 206
Rear View
IRCM-DV+
Control Module
Rear View
To a Control Module
(IRCM, ACM, RCM)
or an IR Link
To an MLS 306/506
Series Switcher or
a 12VDC Power Supply
RS-232
Projector
Connection
MLM Faceplate (rear)
Front Panel Features and Operation
DVD & VCR CONTROL
PLAY NEXT/FWD PAUSE STOP
TUNER
Tx
PREV/REW
ENTER
TITLE MENU
TV/VCR
DVD VCR
51 2
3
4
IRCM-DV+
Front
1
DVD LED — This yellow LED (light-emitting diode) lights
while the MLC’s input associated with the DVD player is
selected.
2
VCR LED — This yellow LED lights while the MLC’s input
associated with the VCR is selected.
LEDs
1
and
2
turn off when an input that is not
associated with that part of the IRCM-DV+ is selected.
The corresponding MLC input must be selected (active)
before either part (DVD or VCR) of the IRCM-DV+ can
be activated and can control the DVD or VCR.
3
Tx (transmit) LED — After the IRCM-DV+ has been set up and
IR commands have been associated with its buttons, this LED
lights whenever one of the IRCM-DVD+’s buttons is pressed.
4
Basic functions buttons — These buttons replicate basic VCR
and DVD player controls. Once they have been set up through
IR learning, these buttons cause the VCR or DVD to rewind,
play, scan forward/move to the next item, or to pause or stop
the video and/or audio.
5
DVD/VCR setup/special function buttons — These buttons
replicate DVD player configuration controls such as the DVD
player’s menu, title, enter, and arrow buttons. They also
replicate VCR controls such as the TV/VCR toggle and tuner
functions. Like the basic functions buttons, these must be set up
via IR learning before they can control the DVD player or VCR.
The optional MLA-Remote infrared remote control
cannot be used to control the IRCM-DV+.