User`s manual

SCP 150 • Remote Communication
SCP 150 • Remote Communication
Remote Communication, cont’d
3-6 3-7
Command/response table for SIS commands (continued) Command ASCII (Telnet) Response Additional
(host to SCP) (SCP to host) information
Volume relative function
Volume up +V/v VolUp Volume down -V/v VolDn
Upload firmware
Upload firmware
Esc
Upload Go When you receive the Go
response, upload the firmware according to your terminal emulator’s procedure.
{Specified number of bytes of data} Upl
When upload is complete, you receive the Upl
response.
Reset to default settings (Zap command)
Reset to factory defaults
Esc
zXXX ZapX Sets all button LEDs to amber.
Special Function SIS Commands
The syntax for setting a special function for an SCP 150 is
X?
*
Y?
* __ #,
where
X?
is the value of the action to be performed,
Y?
is the value for
the button or switch, and __ is the function number. To view a
function’s setting, use __#, where __ is the function number. In the
following table the values of the
X?
and
Y?
variables are different for
each command/function. These values are given in the rightmost
column.