User guide

XTP R HDMI Rear Panel Connectors
POWER
12V
1.0 A MAX
Rx GTx
RS-232 IR
RL
RxTx
-+-+
1
2
AUDIO
ON
AUDIO
RESET
OVER XTP
OUTPUTS RELAYS
SIG LINK
XTP IN
HDMI
OFF
S/PDIF LAN
ab cefghd
Figure 4. XTP R HDMI Connectors
a
XTP connector — Connect a twisted pair cable to the RJ-45 connector labeled
XTP In on the receiver and to an XTP output port on another XTP device to receive all signals
(see TP Cable Termination and Recommendations on page 9). This cable carries the
following signal:
• Digital video
• Digital audio
• Bidirectional RS-232 and IR commands
• Remote power
• Ethernet communication
• System communication
The Link LED lights amber when XTP devices are connected and communication is
established.
The Signal LED lights green when the receiver receives an active HDMI video signal or a test
pattern from the transmitter.
ATTENTION:
• Do not connect this connector to a computer data or telecommunications network.
• XTP remote power is intended for indoor use only. No part of the network that uses
XTP remote power should be routed outdoors (see Remote power on page 12).
b
LAN connector — Connect a control device or device to be controlled to the transmitter
for 10/100 Ethernet communication through this pass-through port. LEDs on the connector
indicate link and activity status.
c
RS-232 Over XTP port — To pass bidirectional serial, Infrared, or other control
signals between XTP-compatible devices, connect a control device to the 5-pole
captive screw connector. The port includes only the 3 poles labeled “RS-232.”
IR Over XTP port — To enable the ability to transmit and receive IR signals (up to
40 kHz), connect a control device to the 5-pole captive screw connector. This port
includes only the 2 poles labeled “IR” and shares the ground pole with the RS-232
port.
NOTE: RS-232 and IR data can be transmitted simultaneously (see RS-232 and IR
Communication on page 10 for wiring details).
d
HDMI output — Connect a digital video display to the female HDMI connector (see HDMI
Audio Switch on page 14 to select local audio output options). It can accept HDMI, DVI (with
an appropriate adaptor), or DisplayPort video signals.
NOTES:
• Maximum cable length is 15 ft.
• Use Extron LockIt lacing brackets to secure HDMI connectors to the device (see
HDMI LockIt on page 8).
• Video input from a DisplayPort source must be a dual mode DisplayPort source.
IR
Tx Rx G Tx Rx
RS-232
IR
Tx Rx G Tx Rx
RS-232
XTP T HDMI Transmitter and XTP R HDMI Receiver • Installation 6