User guide

e
Analog audio output — Connect a balanced or unbalanced, stereo or mono audio
output device to the 3.5 mm, 5-pole captive screw connector for 2-channel stereo
analog audio output. If the device is receiving 2-channel LPCM embedded on the HDMI
input signal and digital is the selected audio input format, it is extracted and converted
to a stereo analog signal.
Do not tin the wires!
Balanced Audio Output
Tip
Ring
Tip
Ring
Slee
ves
Unbalanced Audio Output
Tip
No Ground Here
No Ground Here
Tip
Sleeves
LR
LR
Figure 5. Audio Output Wiring
ATTENTION: For unbalanced audio, connect the sleeves to the center contact
ground. Do not connect the sleeves to the negative (-) contacts.
f
S/PDIF audio output — Connect an audio device to the female orange RCA
connector for digital S/PDIF audio output (see Audio Output Overview on page 15
for supported audio formats on the S/PDIF output). The type of audio present on this
output will be dictated by the following:
• The audio format selected on the source material or device.
• The source device automatically outputting an audio format through EDID.
g
Relays — Connect equipment that can be controlled via momentary or latching
contact, like as projector screens or lifts, to the normally open relays.
ATTENTION: Do not exceed 24 V at 1.0 A for each port.
h
Power connector and LED — Connect the external 12 V, 1.0 A power supply to the
2-pole captive screw connector. The Power LED lights to indicate the device is receiving
power.
NOTE: XTP HDMI transmitters and receivers can be powered remotely
(see Power Connection on page 11).
Front Panel Configuration Port
XTP R HDMI
CONFIG
XTP
HDCP
SIGNAL
AUDIO
HDMI
HBR
S/PDIF
BITSTREAM
ANALOG
LPCM
XTP T HDMI
CONFIG
INPUT
AUDIO SIGNAL CLIP
HDCP
SIGNAL
ANALOG AUDIO
HDMI AUDIO
XTP T HDMI
XTP R HDMI
a
Figure 6. Front Panel Configuration Port
a
Front Panel Config Port — Connect a host device to the female mini-USB B port to
configure the connected transmitter or receiver or update firmware.
XTP T HDMI Transmitter and XTP R HDMI Receiver • Installation 7