Instructions / Assembly

-9-
5.1.4.
Locate two upper and two lower end loops, as well as four O-rings.
5.1.5.
Place one O-ring over the swaged portion of each end loop, then push until it rests against loop
shoulder (FIG. 10).
FIG. 10
5.1.6.
Install one 1/4” x 1” long hex washer head self-drilling screw through the hole in the end
loop attachment plate and into the vertical post of the handrail (FIG. 11).
5.1.7.
Repeat for all end loops, then tighten securely.
If the end loop being installed does not fit correctly, ensure you have the correct loop
for the location. Refer to FIGs. 8 and 9 for upper/lower loop identification.
FIG. 11
6.
INSTALL RAMP CORNER PROTECTOR CAPS
6.1.
Install corner protector caps by placing one cap over each ramp side rail corner at both the top and
bottom of the ramp (FIG. 4 and 12). Construction adhesive can be used to bond the cap to the ramp.
FIG. 12
O-RING
SWAGED PORTION OF END LOOP
O
-RING RESTING
AGAINST SHOULDER
LOOP ATTACHMENT PLATE