Instructions / Assembly

10
Pencil
Phillips Screwdriver
Power Saw
Hole Cutting Template
Ceiling Trim Ring
TOOLS & PARTS
Use a keyhole/drywall saw to cut the hole.
Using the correct (10" or 14") Hole Cutting Guide for
your size tube, and a pencil, locate protruding wire in
the ceiling and trace the diameter of the ceiling inner
hole using the template marked “A”.
Slide the Trim Ring up into your ceiling hole. Make
sure the flip tabs are turned in. Reach through hole
and turn flip tabs out to hold ring in place.
You may have to drill a hole inside the traced diameter
circle to insert saw blade.
TIP
For 14” skylight with 16” on-center rafter
spacing, see below.
IMPORTANT
Secure the ceiling trim ring by tightening the screws.
Rafter
Traced Line
For 14” skylight with 16” on-center rafter spacing, the 14”
template will draw a line that overlaps the rafters.
Be sure to adjust your cutting angle to avoid cutting into
the rafters. (See illustration)
IMPORTANT
Cut Line
Flip Tab
Trim Ring
Section-5
Inside The Room
1
1
2
2
3
4
3
4