Instructions / Assembly

6
Adjustable Tubes
Hole Cutting Template
TOOLS & PARTS
Remove protective film from inside all tubes.
It is recommended that you put all of your tools and
rooftop components in a box or bag for easy transfer
to the roof. See Section 4.
TIP
From the hardware pack, be sure to use the correct
hole cutting template for the selected tube size.
CAUTION
10" & 14"
10” Template
14” Template
Section-3
Prepare The Components
POTENTIAL FIRE HAZARD. After removing
the film lining from the interior of tube shaft,
a reflective inner surface is created. DO NOT
leave tube shaft components unattended or
exposed to direct sunlight prior to full installation.
Exposed surfaces may catch fire or incur heat
damage as a result of focused sunlight until the
tube shaft is fully installed with diffuser in place.
WARNING
1
1