Instructions / Assembly

7
10" & 14"
Select the correct hole cutting template for the tube
(10” or 14”).
Locate the protruding nail. Use the correct hole-cutting
template to trace the diameter of the outer template
hole.
Use a reciprocating/sabre saw to cut the roof hole.
Drill a hole inside the traced circle to insert saw blade.
TIP
Carpenter Pencil
Ladder
Safety Equipment
Power Drill
Power Saw
Hole Cutting Template
TOOLS & PARTS
Rafter
Traced Line
Cut Line
For 14” skylight with 16” on-center rafter spacing, the 14”
template will draw a line that overlaps the rafters.
Be sure to adjust your cutting angle to avoid cutting into
the rafters. (See illustration)
IMPORTANT
For 14” skylight with 16” on-center rafter
spacing, see below.
IMPORTANT
Section-4a
On The Roof
1
1
2
2
3
3