Installation Guide

Velvon Framed Fixed Glass Shower Wall Panel
Please Carefully Read:
The installation instructions before installing. Check to make sure all of the accessories are in the package and
you have the tools needed. It may be necessary to consultyour tile supplier about the correct method for drilling
tiles.
NOTE:
Tempered safety glass is stronger than normal glass but is not unbreakable. A scratch onthe glass or contact
with a hard surface (such as a screw head) can cause it to break. If it doesbreak, it loudly explodes into
thousands of small pieces
Please keep this manual and product code number for future referenceand for
ordering replace ment parts if necessary.
2
Product specifications are subject to change without notice
GENERAL INSTRUCTIONS
Read this manual carefully and completely before proceeding.
It is recommended that you wear safety glasses at all times during the installation.
INSTALLATION OVER CERAMIC TILES
If your shower door is to be installed over ceramic tiles, the tiles should lay completely
under the wall jamb.
Silicone should be used to seal the gap where the ceramic tiles meet the fixed panel.
NOTICE
Caulking : no sealant is required inside the shower, unless otherwise stated.
CARE FOR YOUR SHOWER DOOR
Never use scouring powder pads or sharp instruments on metal pieces or glass panels.
An occasional wiping down with a mild soap diluted in water is all that is needed to keep
the panels andmetal parts
looking new
We recommend wiping the glass panels with a squeegee after each use.