Operation Manual

INSTALLATION AND FITTING

DISHWASHWER

CONNECTION TO THE PLUMBING

The hose must run

between the wall and

the bottom space at

the back of the

dishwasher (b1) so

that it is not squashed

or overstretched.

There should be a fixed

water outlet drain at a

distance of between 25 and

100 cm from the floor. Make

sure that the outlet pipe is

not too rigid, bent or

squashed.

If your dishwasher has a hot

water inlet, connect the pipe

to the hot water tap. In this

case, the maximum

temperature must not

exceed 60ºC. Bear in mind

that this type of water

supply may affect the

washing and drying

capacity of the appliance.

max.

100 cm

min.

25 cm

It is very important for the bend pipe of the outlet hose is located securely in water outlet

so that it cannot disconnet. The operating water pressure (minimum and maximum) must

be between 0,5-10 bar (0,05-1 MPa).

IMPORTANT

Connect the pipe to the

water inlet, tighten the

connection nut and

make sure it is securely

connected to the

appliance.

The water connection pipe is located on the back of the dishwasher: