Operation Manual

19
e n g l i s h
This appliance, which is intended exclusively for domestic use, has been designed for washing
dishes.
Very important: Read all of this manual before installing and using the dishwasher. You will find the
documentation and accessories inside.
This manual is designed so that the text matches the corresponding drawing.
Instruction Manual
Identify your dishwasher model (“a”, “b”, “c”,
“d”, “e” or “f”) by comparing the control panel
with the illustrations.
1.1 Connection to the water supply (1.1.1)
The hose should run between the wall
and the bottom of the dishwasher (1.1.2),
making sure that the pipes are not twisted
or pulled too tight (1.1.3).
The water supply pressure should be
between 0.05 and 1 Mpa (0.5 to 10
kg/cm2)
If your dishwasher has a hot water intake,
you can connect the pipe to the hot water
tap. In this case, the maximum
temperature should not exceed 60ºC.
1.2 Drain. Fit the elbow supplied and
observe the levels in the drawing.
1.3 Connection to the mains electricity
supply. Take the information on the
nameplate (1.3) into account and never
attempt to remove it.
If fitting the appliance under a worktop,
the plug should be accessible after
installation.
1.4 Ensure that the dishwasher is correctly
levelled to avoid functional problems
(1.4.1).
If you are going to fit the appliance under
a worktop, you can do so with or without
the cover.
If you need to remove the cover to fit the
appliance under a worktop (1.4.2 - 1.4.3)
follow the phases indicated in the
drawings (1-2-3). Due to the easy
removal of the cover without the need for
any special tools, it can be considered as
a fitted appliance. In this case, take the
dimensions of the drawing into account
(1.4.4).
0
Identification
1
Installation
With fitted appliances you can level the
back feet from the front. To do this,
before putting it into its space, move it in
slightly and lift it by turning the rear foot
(1.4.5) until a space of around 3mm is
left between the worktop.
Insert the dishwasher and ensure that
the pipes and cable do not get trapped
behind the skirting. Adjust it to the
worktop until the top of the appliance
makes slight contact with it (1.4.6).
To fit it into a line of units with a single
skirting board, unscrew the skirting from
the dishwasher and remove it (1.4.7).
Loosen the feet supports (1.4.8). Screw
the adjustable feet to the dishwasher
(1.4.9-1.4.10). Fit the kitchen skirting and
if opening the door interferes with it, trim
the end until the door can open properly.
If you need to fit a piece of wood to
the front, follow the instructions that
come with the appliance documentation.
2.1 Switch on the dishwasher by pressing
2.2 Language selection. Some type A
dishwashers have a text screen. To
select the language, press the duo-zone
key for more than 3 seconds (2.2.1)
By pressing this several times you will
reach the required language.
Validate by pressing (2.2.2).
2.3 Hard water. Water contains lime and its
hardness increases in direct proportion
to the quantity found.
Before using the dishwasher, you
should find out the hardness level of
the water by consulting the water
company, consulting the Technical
Support Service or using the Aquadur
strip included in the accessories bag.
2
Initial settings