Product Manual

ManualsBrandsFahrenheat ManualsElectric HeatersCeiling-Mount 5,000 Watt Electric Heater — 17,065 BTU, 240 Volts, Single Phase

Model No. UH-524TA

Horizontal / Vertical Unit Heater

(Field Adjustable from 1.9KW @ 208V to 5KW@ 240V)

WARNING

Dear Owner,

Congratulations! Thank you for purchasing this new heater manufactured by a division of Marley

Engineered Products. You have made a wise investment selecting the highest quality product in the heat-

ing industry. Please carefully read the installation and maintenance directions shown in this manual.

You should enjoy years of efficient heating comfort with this product from Marley Engineered Products...

the industry’s leader in design, manufacturing, quality and service.

... The Employees of

Marley Engineered Products

Read Carefully - These instructions are written to help

you prevent difficulties that might arise during installation

of heaters. Studying the instructions first may save you

considerable time and money later. Observe the following

procedures, and cut your installation time to a minimum.

1. Use minimum 75° copper wire only.

2. Heater air flow must be directed parallel to, or away from,

adjacent walls.

3. Observe wall, floor, and ceiling clearance requirements.

4. All wiring must conform to national and local electrical codes

and the heater must be grounded as a precaution against

possible electrical shock. Heater circuit must be protected

with proper fuses. See Table 1 on page 4.

5. The mounting structure and the anchoring hardware must be

capable of reliably supporting the weight of the heater and, if

used, the mounting bracket.

6. All electrical power must be disconnected at the main service

box before installing, inspecting, cleaning or servicing the

heater. This is a precaution to prevent serious electrical

shock.

7. This heater is not suitable for use in hazardous locations as

defined by the National Fire Protection Association (NFPA).

This heater has hot and arcing (sparking) parts inside. Do not

use in areas where gasoline, paint, or flammable liquids

are used or stored.

8. This heater is not suitable for use in corrosive atmospheres

such as marine green houses or chemical storage areas.

9. This heater must be mounted at least 6 feet (1829 mm) off the

floor.

10. This unit only operates on 240 or 208 volts AC. Improper

installation or failure to follow the procedures outlined in this

instruction manual can result in serious electrical shock.

Installation & Maintenance Instructions

SAVE THESE INSTRUCTIONS

FILE #E21609

Summary of content (8 pages)

PAGE 1
FILE #E21609 Model No. UH-524TA Horizontal / Vertical Unit Heater (Field Adjustable from 1.9KW @ 208V to 5KW@ 240V) Installation & Maintenance Instructions Dear Owner, Congratulations! Thank you for purchasing this new heater manufactured by a division of Marley Engineered Products. You have made a wise investment selecting the highest quality product in the heating industry. Please carefully read the installation and maintenance directions shown in this manual.
PAGE 2
INTRODUCTION Mounting Height When the air flow of the heater is directed vertically, the minimum mounting height is 6 feet (1829 mm), the maximum mounting height is 11 feet (3353 mm). When the air flow of the heater is directed horizontally the minimum mounting height is 6 feet (1829 mm) and the maximum recommended height is 8 feet (2438 mm).
PAGE 3
NOTE: The louvers are designed so they can not be completely closed. Do not attempt to defeat this feature, damage to the unit can result. NOTE: Wiring compartment volume = 370 in3 (6063 cm3) Connect the wire to the power terminal block located in the base of the heater (See Fig. 5). NOTE: To decrease the heat output of the heating unit, see Table 1 and schematic diagram on page 4. Turn on the power at the main service.
PAGE 4
Dimension Data Figure 8 HEATING ELEMENT MINIMUM DISTANCE TO WALL 13 in. (330.2 mm) 61/2 in. (165 mm) 14 in. (356 mm) MOUNTING LOCATION 121/2 in. (318 mm) 1/2 in., 3/4 in. (2) (12.7 mm, 19.1 mm) Cleaning the Fan and Motor ! 125/8 in. (321 mm) 13/4 in. (44.5mm) CAUTION FRONT VIEW USE CARE TO PREVENT DAMAGE TO INTERNAL HEATER WIRING WHEN CLEANING ELEMENT. MAKE SURE ALL CONNECTIONS REMAIN TIGHT AND ALL WIRING IS ROUTED AWAY FROM ELEMENT FINS WHEN REASSEMBLING THE UNIT.
PAGE 5
Modéle N° UH-524TA Dossier E21609 Appareil de chauffage (aérochauffeur) horizontal / vertical (Réglable sur place de 1,9 kW sous 208 V à 5 kW sous.) Notice d’installation et d’entretien Cher utilisateur, Félicitations ! Nous vous remercions d'avoir fait l'acquisition de ce nouveau radiateur fabriqué par une division de Marley Engineered Products. Vous avez fait un bon investissement en choisissant un appareil de qualité imbattable.
PAGE 6
INTRODUCTION Votre nouvel appareil de chauffage a une souplesse de fonctionnement sans rivale, conçue pour satisfaire diverses exigences en commutant simplement quelques conducteurs facilement accessibles, situés à la base de l'appareil. Avec une production de chaleur comprise entre 6.396 et 17.065 BTU par heure, cette particularité, unique en son genre, vous permet d'utiliser un appareil unique pour satisfaire une gamme étendue d'applications de chauffage.
PAGE 7
dégagement suffisant et empêcher une surchauffe possible. C. Ajustant les persiennes à la position désirée. REMARQUE : les persiennes sont conçues de sorte qu'elles ne puissent être complètement fermées. N'essayez pas de contourner cette particularité, cela pourrait endommager l'appareil. Connectez le fil au bloc de bornes d'alimentation situé à la base de l'appareil de chauffage (voir fig. 5).
PAGE 8
Données dimensionnelles Figure 8 ÉLÉMENT CHAUFFANT 14 po (356 mm) DISTANCE MINIMUM AU MUR 13 po (330 mm) 61/2 po (165 mm) EMPLACEMENT DE MONTAGE 121/2 po (318 mm) ! 1 MISE EN GARDE Nettoyage du ventilateur et du moteur Enlevez la grille de protection de l'arrière de l'appareil de chauffage. Figure 9 GRILLE DE PROTECTION VENTILATEUR ET MOTEUR Cela donne accès au ventilateur et au moteur. Essuyez le ventilateur et le moteur avec un chiffon doux ou une brosse à poils doux.