B Series Specifications
11
F A L C O N B S E R I E S
H O W T O O R D E R
How to Order
For correct ordering, and to ensure no delays in shipment of
your order, the following descriptive data must be listed in the
sequence shown. Necessary information can be found in other
parts of this catalog. The example below shows an order for 12
each B locksets in the 301 Privacy function, D (Dane) trim design
in a 626 (satin chrome) nish, with 2-3/4” backset latch, to
accommodate doors 1-3/4” thick.
Quantity: Indicate the quantity required.
Catalog Number: Select catalog number.
Trim Design: Indicate letter of lever design. D=Dane;
Q=Quantum.
Finish: When the nish is the same for the outside and inside
trim, it is shown once (626). For split nishes, the outside is
designated rst, then the inside (605 x 625).
Latches: 2-3/4” backset standard. 2-3/8” backset available.
All latches are UL Listed 1-1/2 hour B Label.
Strikes: 4-7/8” x 1-1/4” ANSI strike standard. Optional T-Strike
or Full Lip Strike available. See page 7.
Cylinder Type: For 6-pin, add 6-pin.
Keying Detail: We suggest using the standard terms developed
by A.H.C. (Architectural Hardware Consultants). EXAMPLE:
AA1–Grand Master keyed, Master keyed, change key 1.
Interchangeable Core: To order product capable of accepting
an interchangeable core, add “FIC” (for interchangeable core). To
order product with an interchangeable core, add “WIC”
(with interchangeable core).
Keyways: “G” is standard on regular cylinders, “A” is standard on
interchangeable cores. Other keyways available. See page 7.
Additional Keys: Note the total number of keys required. Large
Bow Keys: Add–“with large bow keys.”
How to Order Example
Qty.
Catalog
Number
Trim
Design
Finish Latch Strike Cylinder Detail
12 B301S DAN 626 STD STD - 2-3/4” Backset- 1-3/4” Door
Finishes
The latest in modern techniques and equipment are used to apply
the highest quality nish. Extra steps assure durable, consistent
nishes and long useful life.
Although we apply the nest available protective plating and/or
clear-coat powder coating to the surface of our products, these
nishes have limitations and in time may deteriorate either from
exposure to weather, pollution, perspiration, extremes of climate,
frequency of use or other factors. Deterioration of these nishes is,
therefore, not a defect, but a normal process which is unavoidable.
Our company cannot accept responsibility for nish deterioration in
these circumstances; therefore, the nishes cannot be guaranteed.
These products will not be renished or replaced under our warranty
should deterioration of nishes occur.
Description ANSI Number Available on
Bright Brass 605 All Trim
Satin Brass 606 All Trim
Satin Bronze 612 All Trim
Satin Bronze Oil Rubbed 613 All Trim
Bright Chrome 625 All Trim
Satin Chrome 626 All Trim
Trim Finishes Chart