Specification Sheet

PRODUCT SPECIFICATIONS
Contractor 1-D Full Body Harness #7016
Features
Material Specifications
Webbing: Polyester; Min. 5,000 lbs. tensile strength
D-Rings: Alloy Steel; Min. 5,000 lbs. tensile strength
Buckles/Adjusters: Alloy Steel; Min. 3,375 lbs. tensile strength
Performance Specifications
Tensile Strength: Min. 5,000 lbs.
Max. Capacity: 425 lbs.
Relevant Standards
OSHA: CFR1926.502, CFR1910.66
ANSI: A10.32-2004, Z359.1-2007, Z359.12-2009
Warnings
· Read, understand and follow all labels and
instructions prior to use.
· Inspect before each use.
· Remove from service if there is evidence of
damage or excessive wear.
· Never attach a Shock Absorbing Lanyard to
the front or side D-Rings.
UNDERSTOOD PRIOR TO USE. FAILURE TO READ AND FOLLOW ALL PRODUCT WARNINGS AND INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH.
· Single back d-ring for fall arrest.
· 5-point adjustability.
· 9-position tongue buckle leg straps.
· 1 lanyard keeper.
· Size: universal fit.
FallTech 1306 S. Alameda St. Compton, CA 90221 Tele: 323-752-0066 www.falltech.com
WARNING: THIS SPECIFICATION SHEET PROVIDES AN OVERVIEW OF PRODUCTS AVAILABLE FROM FALLTECH. CARE HAS BEEN TAKEN TO ASSURE THE ACCURACY OF
THE INFORMATION. IT DOES NOT PROVIDE IMPORTANT PRODUCT WARNINGS AND INSTRUCTIONS. FALLTECH RECOMMENDS ALL USERS OF FALL PROTECTION
EQUIPMENT UNDERGO THOROUGH TRAINING, AND THAT ALL WARNINGS AND INSTRUCTIONS PROVIDED WITH THESE PRODUCTS BE THOROUGHLY READ