Installation Guide

How to Wire Your Ceiling Fan

Hanger Bracket

Receiver

Dip Switch

NOTE: Supply wires

omitted for clarity

NOTE: If fan or supply wires are different colors than indicated, have this unit installed by a qualified electrician.

Figure 1

Figure 3

Dip Switch

1 2 3 4 5

1. To set the code on receiver unit, slide dip switches to

the same positions as set on the remote control.

(Figure 1)

NOTE: The remote unit has 32 different code

other remote units, simply change the combination code

NOTE: Factory setting is all up. Do not use this position.

2. Slide the receiver into the hanger bracket before wiring

as shown in figure 3.

Receiver Unit

MAIN FUSE BOX

Figure 2

NOTE:

If you are not sure if the outlet box is

grounded, contact a licensed electrician for advice, as

it must be grounded for safe operation.

WARNING

To avoid possible electrical shock, be sure electricity is

turned off at the main fuse box before wiring. (Figure 2)

Remote Control

Dip Switch