Installation Guide

3V CR2032
Battery (2 pcs)
Figure 4
4. To make fan operational, install two 3V batteries
(included) in hand-held remote transmitter, with fan
power off. Then, follow the remote code setting
process. If not used for long periods of time, remove
battery to prevent damage to transmitter. Store the
remote away from excessive heat or humidly.
(Figure 4)
WARNING
Chemical Burn Hazard. Keep batteries away from
children.
15
How to Operate Your Ceiling Fan (Continued)
NOTE: Factory setting is all up. Do not use this
position.
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
Remote
Control
Dip Switch
Figure 5
Figure 6
Figure 7
6. Replace battery cover on the remote control and
secure with the previously removed screw. (Figure 6)
5.
To set the remote code same positions as the
receiver with a small screwdriver or ball point pen
(neither included), slide dip switches firmly up or
down. (Figure 5)
7. Remote functions: (Figure 7)
• Indicator LED light: fan speed and light dimmer
indicator
• button: Tap once to turn off the fan. Press and
hold this button for 5 seconds to turn on or turn off
the buzzer.
• Fan Speed:
Turn on fan and turn speed up.
Turn on fan and turn speed down.
• Sleep Timer:
The fan and light will turn off after 1 hour.
The fan and light will turn off after 3 hours.
The fan and light will turn off after 6 hours.
• Light button: Turn ON\OFF the light.
Press to turn on the light and hold to dim or
brighten light to desired level, then release.
Press this button to switch color temperature
when the light is on.