Installation Guide

9
8. ATTACHING THE FAN
BLADES
Caution: Remove 5 rubber packing mounts and
discard before installation.
Step 1 Attach the blade to the blade bracket using
the screws and fiber washers as shown in Figure
18. Start screw into bracket. Repeat for the two
remaining screws.
Step 2 Tighten each screw. Make sure the blade is
straight.
Step 3 Fasten blade assembly to motor using the
screws supplied. (Fig. 18)
Figure 18
Figure 19
9. INSTALLING THE
LIGHT KIT
(OPTIONAL)
NOTE: Before starting installation, disconnect the
power by turning off the circuit breaker or removing
the fuse at fuse box. Turning power off using the
fan switch is not sufficient to prevent electric shock.
Step 1. Remove the switch housing cover from the
switch housing.
Step 2. Raise and hold the light kit close to the switch
housing and proceed to do the wire connections,
connect the blue wire from the switch housing to the
black wi
re from the light kit. follow the same procedure
with the black connectors. Use the wire connecting
nuts supplied with your fan. (Fig. 19)
Step 3. Attach the light kit to the switch housing by
using the three (3) screws provided. (Fig. 19)
Light kit
Screws
Switch
housing
Wire nuts
Screws
Blade
Blades bracket
Screws
Fiber
washers
10
Figure 20
Figure 21
10. INSTALLING THE
LIGHT BULBS AND
GLASS SHADES
(OPTIONAL)
NOTE: Before starting installation, disconnect the
power by turning off the circuit breaker or removing
the fuse at fuse box.
Turning power off using the fan switch is not
sufficient to prevent electric shock.
1. Insert the glass shades into the light kit with the
thumb screws. (Fig. 20)
2. Install 40W candelabra bulbs (included).
(Fig. 20)
Glass shades
Bulbs
Bulbs
Screws
Light kit
Light kit
Glass Bowl
3. Restore power and your light kit is ready for
operation.
1. Install 60W candelabra bulbs (included).
(Fig. 21)
2. Secure bowl glass to light fitter using supplied
nut. Next install trim cover followed by the finial.
3. Restore power and your light kit is ready for
operation.