Instructions

ANTENNA
BLACK
AC POWER SUPPLY
(Mains/Live)
(Mains/Neutral)
WHITE
BLACK
BLUE
(Light/Live)
(Fan/Neutral)
WHITE
(Fan/LIVE)
BLACK
CR2430 3V
Figure 3
Figure 4
Figure 5
How to Wire and Operate Your BTCR9 Remote Control
Copyright 2014 Fanimation
2014/12 V.01
10983 Bennett Parkway
Zionsville, IN 46077
[phone] • FAX [phone]
Outside U.S. call [phone]
Visit Our Website @ www.fanimation.com
NOTE: If fan or supply wires are different colors than indicated, have this unit installed by a qualified electrician.
Figure 1
Figure 2
ON DIP
Dip Switch
Dimmer Switch
WARNING
CAUTION: INCORRECT WIRE CONNECTION WOULD
DAMAGE THIS RECEIVER.
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.NOTE: If
you are not sure if the outlet box is grounded, contact a
licensed electrician for advice, as it must be grounded
for safe operation.
: Turns off ceiling fan.
: Turns on ceiling fan to high speed
: Turns on ceiling fan to medium speed
: Turns on ceiling fan to low speed
To use your smart device to control your receiver,
download the fanSync app from your app store.
6. Installing Wall Plate: (Figure 5)
Attach wall plate using the two provided screws.
1. Ceiling fan must be set at HIGH speed and light kit (If
any) in the ON position.
2. Connect wires using connectors as shown in Figure 1.
3. Once the connection has been made, slide the receiver
into the hanger bracket, taking care not to pinch the wires.
The canopy comes up to cover the receiver and hanger
bracket. (Figure 2)
4. Pairing Process for Receiver & Transmitter: (Figure 3)
– The receiver and accompanying transmitter are matched
at the factory. If replacing transmitter or receiver, you must
follow the pairing process below before using the unit. The
fanSync receiver can be paired to up to five (5)
transmitters. NOTE: Smart device pairing is unlimited.
– After installing the receiver unit, set desired transmitter
code by pushing dip switches (under battery cover) up or
down to the desired positions. Once code is set, restore
power to your fan and press and hold the fan off button ( )
for approximately 1 to 3 seconds. Fan will turn off, then
turn on to medium speed to indicate that the pairing
process is complete. Please note that you must press the
fan off button ( ) within 30 senconds after restoring
power. Re-pairing your device is not necessary after
replacing the battery. Each fanSync receiver can pair to
five different transmitters (with different dip switch codes).
If light kit uses CFL bulbs, please slide the “light dimmer
function select switch” to on/off position. If incandescent
light bulbs are installed, please slide the “light dimmer
function select switch” to dimmer position.
NOTE: Transmitters can pair to multiple receivers, when
performing the pairing process take care not to pair the
transmitter to unintended receivers. It is suggested that fans
more than seven feet apart be on separate power switches.
5. Functions of Transmitter (Figure 4)
LIGHT ON/OFF: Press and release button
immediately to turn light on or off.
LIGHT DIMMER: Press and hold to dim or
brighten light to desired level and release.
Dimming feature is not available with certain bulbs, i.e. CFLs
DIMMER
ON/OFF