Instruction Manual

13
3. It is recommended to program the camera to the most frequently used underwater photo mode,
lighting and other key settings prior to installing the camera in the housing.
PREPARING THE HOUSING
1. When using the housing for the first time-
a. Peel the screen protector off the back side of the housing.
b. Install the hand lanyard on the housing by inserting it through the lanyard loop on the
bottom right of the housing (facing from back), then pulling it through itself and testing it
in order to make sure it is secure (image #1).
c. Install the housing side of the diffuser quick release secure line by tying it around the
hinge found at the left side of the housing, where the Fiber Optic Cable Plate secure
string is attached to (image #2). Please note that this line may come assembled and then
there is no need for installation.
d. Open the housing (see section “Opening the Housing” on the following page) and remove
the anti-glare hood out of the housing. Secure the anti-glare hood to the housing by tying
its secure string to the hinge found at the left side of the housing, where the Fiber Optic
Cable Plate secure string is attached to. Install the anti-glare hood over the anti-glare
hood rails at the back of the housing. First install the anti-glare hood over the top rail
(image #3 on the following page) and then gently and carefully stretch it downwards to
install it on the bottom rail (image #4 on the following page).
e. If making use of a hand strap (optional), install it on the two loops found at the right side
of the housing.
f. It is important that a first dive with the housing is always made without the camera in
order to verify that the housing watertight seal has not been affected during transport
and after long periods of storage.
Image #1
Image #2