Instruction Manual

16
3. Lift the housing mode dial so it doesn’t interfere with camera installation (image #9).
4. Hold the camera parallel to the housing and then gently install it inside (image #10). Avoid
inserting one side of the camera prior to the other, as this will make the installation difficult and
might cause damage to the camera or housing.
5. In the event of an optional leak detector installed inside the housing, take special care not to
touch or damage the leak detector when installing the camera. Also be careful not to harm the
moisture sensor attached to the leak detector.
6. Once the camera is inserted inside the housing, push the
housing mode dial back down, so it touches the camera
mode dial.
7. If inserting a silica gel pack inside the housing in order to
prevent moisture, it is best to insert it on the right side of
the camera (image #11), where it doesn’t interfere with
proper housing operation. It is important to make sure that
the silica gel pack doesn’t stick out, or else it might
interfere with the watertight seal of the housing.
CLOSING THE HOUSING
1. Turn the latch dial so that the small red tab located on the latch is pointed towards the front side
of the housing (image #12 on the following page).
2. Carefully close the back door of the housing, pushing it against the front door.
Image #9
Image #10
Image #11
MODE
DIAL