Installation Guide

ManualsBrandsFavorite Monkey ManualsLighting & Ceiling FansSnap 3-Pack 12-in Hardwired Light Bar Under Cabinet Lights

This document is intended for reference only by qualified electricians and should not be considered a substitute for national, state and local electrical

codes.

• THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH THE NEC, STATE AND LOCAL CODES.

• DO NOT USE A FIXTURE IF THE HOUSING, LENS OR POWER CABLES ARE DAMAGED.

• TO AVOID RISK OF AN ELECTRICAL SHOCK, PLEASE SHUT OFF THE MAIN POWER BEFORE INSTALLING AND WIRING THIS UNIT.

• DO NOT ATTEMPT TO OPEN THIS FIXTURE AS IT CONTAINS NO USER SERVICEABLE PARTS.

A. Selecting a Power Supply

For compliant operation, Favorite Monkey fixtures must be operated with a suitable UL listed Class 2 power supply. Please select a

power supply that is compatible with your lighting requirements. The power supply selected can either drive a single fixture or a series of

multiple connected fixtures. Proper power supply selection is determined by the wattage of the fixtures installed and this selection is the

sole responsibility of the installer. Do not exceed the wattage limits of the power supply. The total wattage of the series or string of

fixtures is additive and must be lower in value than the power supply rating. The installer can purchase the power supply from Favorite

Monkey or any supplier offering a suitable Class 2 power supply.

B. Installing the Power Supply

1) Identify the location for the power supply.

2) When using a single power supply and multiple fixtures, the fixtures are installed in series or in an array format

using the splitter accessory (Figure 1). The fixtures may be ordered with accessories (see Figure 1). Use the connector cables

(see Figure 2) when distance is needed between fixtures. Use the connector (see Figure 2) when end-to-end installation is

needed to provide uniform and smooth light distribution. Use the splitter when formatting an array series (see Figure 1).

Figure 1:

Connector

Accessory

Connector Cable

Accessory Splitter Accessory

Figure 2:

C. Installing SNAP fixtures

1) Fixtures mount by affixing the included bracket with screw. The fixtures can be mounted in an enclosed area

using any orientation necessary for proper product illumination (see Figure 3).

Summary of content (2 pages)

PAGE 1
This document is intended for reference only by qualified electricians and should not be considered a substitute for national, state and local electrical codes. • THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH THE NEC, STATE AND LOCAL CODES. • DO NOT USE A FIXTURE IF THE HOUSING, LENS OR POWER CABLES ARE DAMAGED. • TO AVOID RISK OF AN ELECTRICAL SHOCK, PLEASE SHUT OFF THE MAIN POWER BEFORE INSTALLING AND WIRING THIS UNIT.
PAGE 2
Figure 3: D. Making Electrical Connections If you wish to hard wire the power supply directly to the AC mains, have a qualified electrician connect the line voltage to the input side of the power supply in accordance with national, state and local electrical codes using an appropriate junction box (not included). 1) Isolate from the mains supply before installation 2) Wire the LED fixture onto the DC output of the driver using the pigtail.