Operation Manual

ManualsBrandsFe Powertools ManualsDrillL - FE 100 R

2 Manual magnetic drilling machines

1. Table of contents

2. Table of contents

3. Safety procedures

4. Technical overview

5. Operating manual

5.1 Hole cutter selection

5.2 How to mount tools or adapters in a Weldon arbor

5.3 Drilling with hole cutters

5.4 Drilling with twist drills

5.5 Tapping / threading

5.6 Speed and torque setting

6. Tips and tricks

7. Maintenance

8. CE Declaration of Conformity

9. Warranty

Summary of content (6 pages)

PAGE 1
Manual magnetic drilling machines 1. Table of contents 2. Table of contents 3. Safety procedures 4. Technical overview 5. Operating manual 5.1 Hole cutter selection 5.2 How to mount tools or adapters in a Weldon arbor 5.3 Drilling with hole cutters 5.4 Drilling with twist drills 5.5 Tapping / threading 5.6 Speed and torque setting 6. Tips and tricks 7. Maintenance 8. CE Declaration of Conformity 9.
PAGE 2
3 Manual magnetic drilling machines Manual magnetic drilling machines 1. Safety procedures 2. Technical overview FE 30 When using magnetic drilling machines please follow the general safety instructions for electric power tools.
PAGE 3
5 Manual magnetic drilling machines 3. Operating instructions 4.1 Hole cutter selection Before starting to drill make sure the cutter of your choice is the right one for the job you want to do. Following cutters are available in the Fe Powertools program: Manual magnetic drilling machines 4.2 How to mount tools or adapters in a Weldon arbor? 1) Make sure the machine is disconnected from the power supply. 2) Put the center pilot in the cutter hole.
PAGE 4
7 Manual magnetic drilling machines 8 9 Still it is not necessary to use a lot of pressure. Too much pressure will cause damage and breakage. After the cut is finished the slug will automatically be ejected from the cutter, switch the machine off by pushing the red button(0). If the slug gets stuck in the cutter, move the machine to a flat surface. Switch on the magnet and gently bring the cutter down in contact with the surface. This usually allows a slug to straighten and to eject.
PAGE 5
9 Manual magnetic drilling machines Manual magnetic drilling machines 4. Tips and Tricks TIP: Do not use your magnetic drill on the same structure when ARC welding is in progress. D.C. current will earth back through the magnet and cause irreparable damage. Start bringing the tap to the workpiece but handle with care and do not apply pressure. When the tap touches the material it is automatically pulled into the material. After you will have to use minimum pressure to feed the tap.
PAGE 6
11 Manual magnetic drilling machines Manual magnetic drilling machines Switches and cables: Check switches, cables and buckling protection for damages at regular intervals. Carbon brushes: Check carbon brushes and replace them in time. Used carbon brushes leave fine dust that deposits in the upper part of the motor. Therefore clean the upper part of the motor regularly. This way, swarf that might have come into the motor through ventilation gaps are also removed.