Operation Manual

11 Manual magnetic drilling machines
Switches and cables: Check switches, cables and buckling protection for damages at regular
intervals.
Carbon brushes: Check carbon brushes and replace them in time. Used carbon brushes leave fine
dust that deposits in the upper part of the motor. Therefore clean the upper part of the motor
regularly. This way, swarf that might have come into the motor through ventilation gaps are also
removed. Damages on armature, winding and the motor board are reduced.
6. CE Declaration of Conformity
The product conforms to the basic requirements of the relevant CE directives. A conformity
assessment method as provided in the directives has been executed.
Company: FE Powertools BV
A van Leeuwenhoekweg 36B9
2408 AN Alphen aan den Rijn
The Netherlands
For verification in accordance with guideline for machines 98/37/EEC. The low‐voltage directive
73/23/EEC modifications inclusive the following standards were applied:
DIN EN 61029‐1
For verification in accordance with EMC directive 89/336/EEC modifications inclusive the following
standards were applied:
EN 61000‐3, EN 50082‐1‐.19921,
EN 55014‐1993, 55104‐1995
The following technical documentation is available for inspection:
‐ Operating manual
‐ Constructional drawing
‐ Test documents
‐ Other technical documentation
Alphen aan den Rijn, 01‐01‐2010
Mark Korsten
Director
12 Manual magnetic drilling machines
7. Warranty
The warranty period for FE Powertools equipment is 12 months as of the date of purchase.
Damages due to wear and tear, overload or improper handling of the machine are excluded from
warranty. Damages that are due to fault in material or defect in fabrication will be remedied free of
cost by compensation delivery or repair.
Complaints can only be accepted if the device is send undismantled and free of charge to Fe
Powertools or to a competent service partner.
Claims for damages cannot be derived from this warranty .
Please fill out the warranty or add the purchase receipt.
MACHINE TYPE : …………………………………………………………………………..
MACHINE NUMBER : …………………………………………………………………………..
DATE OF PURCHASE : ……………………………………………………………………………
STAMP/SIGNATURE SPECIALISED DEALERS : ……………………………………………………………………………
ERROR DESCRIPTION: